Compare Colors Compare Colors

EZ-Xtend Drip Shield - Straight

Product Code:
EZ1008

Usually Ships in 1 to 2 Business Days
$3.60
Adding to cart… The item has been added

EZ-Xtend Straight Drip Shield Bimini Top Rain Shields



  • Straight Drip Shields are for use between two enclosure panels.
  • They do not round the corner like corner drip shields.
  • Drip shields are stick-on clear vinyl shields that keep out the elements between two enclosure panels on your Bimini top, helping to close any gaps that exist.
  • Stick on adhesive works with Sunbrella and all other marine fabrics.
  • Click here for Instructions 
Return to EZ Drip Shields page



Drip Shield Installation

 

Drip Shield Installation

Tools required:

  • Reasonably sharp scissors
  • Soap
  • Water
  • Scrub brush

1. Thoroughly clean fabric where drip shields will be secured. If

that means soap and stiff bristled brush to remove all mold,

mildew and loose dirt etc., then do so.

2. Remove any old Velcro and thread. You want the shields to

have flat, clean fabric to adhere to.

3. Let dry completely.

4. Hold drip shield up to determine the best location. This is the

time to trim to desired size should it be needed before

paper is peeled off the adhesive.

5. Once you are sure about the location and position. Peel and

stick drip shields in place. Drip shields should not be lifted

and stuck over and over. This will weaken the adhesive.

Get it right the first time.

6. Press fabric and adhesive together, using strong finger

pressure to make a secure bond.

7. Allow adhesive to set 24 hours before exposure to excessive wind,

or water. This is an aggressive adhesive. The bond strengthens as

sets.